Verdent Diamond-Like Carbide HP Burs Coarse Cross Cut

Verdent Diamond-Like Carbide Coarse Cross Cut Burs

Available in: 

• Coarse cross cut
• HP shank
• Sizes in: 040, 060
• 1 piece per pack
• For reduction of plaster, resin-based materials, and plastic
• Superior hardness and wear resistance
• Extended tool life and durability
• Reduced friction and cooler cutting
• Higher cutting efficiency and speed
• Optimised for hard and abrasive material

Sterilisation and Cleaning

• Before first use, immerse instruments in a suitable disinfectant solution for approximately 30 minutes

After each use:

• Clean thoroughly using distilled water or running water
• Do not use sodium hypochlorite, as it may cause corrosion

Sterilisation:

• Sterilise using a steam autoclave under the following conditions:
• • 121°C for 15 minutes, or
  • 134°C for 5 minutes

The number of sterilisation cycles is limited by the product’s lifespan and should not exceed 10 cycles